BRAKE BOOSTER(for LHD) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the brake booster assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system

Click here

Lane departure alert system (w/ Steering Control)

Click here

Pre-crash safety system
Adaptive high beam system
Reset power trunk lid Power trunk lid system

Click here

CAUTION / NOTICE / HINT

Note

Make sure to release vacuum from the brake booster assembly before removing the brake master cylinder sub-assembly from the brake booster assembly.

PROCEDURE


  1. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  2. REMOVE BRAKE ACTUATOR ASSEMBLY WITH BRACKET

    Click here

  3. REMOVE BRAKE PEDAL RETURN SPRING

    B002DD5

    1. Remove the brake pedal return spring from the steering column assembly and push rod pin.

  4. REMOVE PUSH ROD PIN

    Click here

  5. REMOVE FRONT WHEEL LH

    Click here

  6. REMOVE FRONT NO. 3 BRAKE TUBE


    1. A01QCLKC01
      *1 Front Flexible Hose
      *2 Grommet

      Using a union nut wrench, disconnect the front No. 3 brake tube from the front flexible hose.

    2. Disengage the grommet.

    3. A01Q92O

      Disengage the clamp and remove the front No. 3 brake tube.

      Note


      • Do not kink or damage the front No. 3 brake tube.

      • Do not allow any foreign matter such as dirt or dust to enter the front No. 3 brake tube from the connecting parts.

  7. REMOVE BRAKE BOOSTER ASSEMBLY


    1. B002EPJ

      Remove the 4 nuts and brake booster assembly from the vehicle body.

      Note

      Do not kink or damage the brake lines.

  8. REMOVE BRAKE BOOSTER GASKET


    1. Remove the brake booster gasket from the brake booster assembly.

  9. REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS


    1. Loosen the clevis lock nut and remove the brake master cylinder push rod clevis and clevis lock nut from the brake booster assembly.

  10. REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY


    1. Remove the brake vacuum check valve assembly from the brake booster assembly.

  11. REMOVE CHECK VALVE GROMMET


    1. Remove the check valve grommet from the brake booster assembly.