REAR BRAKE INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL REAR DISC


    1. B002CUM

      Check the identification mark to determine the installation side.

      Note

      The rear disc needs to be installed to the correct side of the vehicle. There is a "LEFT", indicating the disc for the left wheel, or a "RIGHT", indicating the disc for the right wheel, engraved on the disc in the position shown in the illustration.

    2. When reusing the rear disc:


      1. B002F09C01
        *a Matchmark

        Align the matchmarks of the rear disc and rear axle hub and bearing assembly, and install the rear disc.

    3. When replacing the rear disc:


      1. Inspect the rear disc runout.

        Click here

      2. Select the installation position where the rear disc has minimal runout, and install the rear disc.

    4. Temporarily install the hub nut.

  2. INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG


    1. Install the parking brake shoe adjusting hole plug to rear disc.

  3. INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY


    1. Install the rear disc brake cylinder assembly to the rear axle carrier sub-assembly with the 2 bolts.

      Torque:
      125 N*m  { 1275 kgf*cm, 92 ft.*lbf }

  4. CONNECT REAR FLEXIBLE HOSE


    1. Connect the rear flexible hose to the rear disc brake cylinder assembly with a new union bolt and a new gasket.

      Torque:
      39.2 N*m  { 400 kgf*cm, 29 ft.*lbf }

      Note

      Install the rear flexible hose lock securely into the lock hole in the rear disc brake cylinder assembly.

  5. INSTALL REAR DISC BRAKE ANTI-SQUEAL SHIM KIT

    Click here

  6. INSTALL REAR DISC BRAKE PAD

    Click here

  7. BLEED BRAKE LINE

    Click here

  8. ADJUST PARKING BRAKE

    Click here

  9. INSTALL REAR WHEEL

    Click here

  10. PERFORM PARKING BRAKE SHOE BEDDING

    Click here