BRAKE PEDAL(for RHD) INSTALLATION

PROCEDURE


  1. INSTALL BRAKE PEDAL PAD


    1. Install the brake pedal pad to the brake pedal support assembly.

  2. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY


    1. Install the brake pedal support assembly with the 4 nuts.

      Torque:
      12.7 N*m  { 130 kgf*cm, 9 ft.*lbf }

  3. INSTALL PUSH ROD PIN


    1. A01QCAOC01
      B002EJY Lithium Soap Base Glycol Grease

      Apply lithium soap base glycol grease to the push rod pin.

    2. B002CLL

      Connect the brake master cylinder push rod clevis to the brake pedal support assembly with the push rod pin, and install a new clip as shown in the illustration.

      Note

      Be sure to install the push rod pin in the correct direction.

  4. INSTALL STOP LIGHT SWITCH ASSEMBLY


    1. Temporarily install the stop light switch assembly to the brake pedal support assembly.

      Click here

      Tech Tips

      Fully tighten the stop light switch assembly lock nut after adjusting the brake pedal height.

    2. Engage the 2 clamps to install the wire harness to the brake pedal support assembly.

    3. Connect the 2 connectors.

  5. INSTALL INSTRUMENT PANEL REINFORCEMENT ASSEMBLY WITH AIR CONDITIONING UNIT

    Click here

  6. INSPECT AND ADJUST BRAKE PEDAL

    Click here