YAW RATE AND ACCELERATION SENSOR INSTALLATION

PROCEDURE

1. INSTALL NO. 1 CONSOLE BOX MOUNTING BRACKET

   
   

   1. Engage the 2 hooks to install the No. 1 console box mounting bracket.

   2. Install the 3 bolts.

      Torque:

      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

   3. Engage the 3 clamps to install the wire harness to the No. 1 console box mounting bracket.

2. INSTALL YAW RATE AND ACCELERATION SENSOR (YAW RATE SENSOR)

   
   

   1. Install the yaw rate and acceleration sensor (yaw rate sensor) with the 2 nuts.

      Torque:

      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note

      
      

      • Do not drop the yaw rate and acceleration sensor (yaw rate sensor).

      • If the yaw rate and acceleration sensor (yaw rate sensor) is dropped, replace it with a new one.

   2. Connect the connector to the yaw rate and acceleration sensor (yaw rate sensor).

      Note

      Make sure that the yaw rate and acceleration sensor (yaw rate sensor) connector is connected securely.

   3. Install the No. 1 console box duct to the No. 1 console box mounting bracket with the 2 clips.

3. INSTALL NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY

   Click here

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Click here

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

5. PERFORM YAW RATE AND ACCELERATION SENSOR AND ROLL RATE AND VERTICAL ACCELERATION SENSOR ZERO POINT CALIBRATION

   Click here