REAR SPEED SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

  • The rear speed sensor rotor is a component of the rear axle hub and bearing assembly. If the rear speed sensor rotor is malfunctioning, replace the rear axle hub and bearing assembly.

PROCEDURE


  1. INSTALL REAR SPEED SENSOR


    1. Insert the connector and grommet of the rear speed sensor into the inside of the vehicle through the hole in the wheel house.

      B002CIQC01
      *A for LH Side *B for RH Side
      *a Connector *b Grommet
      *c Band Clamp *d Grommet Installation Range
      B002CU5 Outside of Vehicle B002CVE Top of Vehicle

      Note

      Make sure the band clamp remains on the outside of the vehicle.

    2. Hold the tube of the grommet and pull it toward the outside of the vehicle, then secure the grommet to the vehicle body as shown in the illustration.

      Note


      • When pulling out the grommet, do not grip the sensor wire.

      • Secure the grommet in place within the range shown in the illustration.

    3. Install the 2 sensor clamps with the 2 nuts.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

      Note

      Do not twist the rear speed sensor wire harness when installing it.

    4. Return the rear wheel house liner to its original position.

    5. Install the 2 sensor clamps and rear speed sensor to the rear axle carrier sub-assembly and rear No. 2 upper control arm assembly with the 3 bolts.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note


      • Prevent foreign matter from attaching to the rear speed sensor tip.

      • Firmly insert the rear speed sensor body into the rear axle carrier sub-assembly before tightening the bolt.

      • After installing the rear speed sensor to the rear axle carrier sub-assembly, make sure that there is no clearance between the rear speed sensor stay and rear axle carrier sub-assembly. Also make sure that no foreign matter is stuck between the parts.

      • Do not twist the rear speed sensor wire harness when installing it.

    6. Connect the pad wear indicator wire connector to the rear speed sensor.

      Note

      Do not twist the pad wear indicator wire when installing it.

    7. Connect the rear speed sensor connector.

      Note

      Do not twist the rear speed sensor wire harness when installing it.

    8. Return the luggage compartment trim cover to its original position.

  2. INSTALL REAR WHEEL HOUSE LINER


    1. Install the rear wheel house liner with the 2 nuts.

  3. INSTALL REAR WHEEL

    Click here

  4. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  5. INSTALL LUGGAGE COMPARTMENT TRIM COVER RH

    Tech Tips

    Use the same procedure described for the LH side.

  6. CHECK FOR SPEED SENSOR SIGNAL

    Click here