REAR SPEED SENSOR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

  • The rear speed sensor rotor is a component of the rear axle hub and bearing assembly. If the rear speed sensor rotor is malfunctioning, replace the rear axle hub and bearing assembly.

PROCEDURE


  1. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  2. REMOVE LUGGAGE COMPARTMENT TRIM COVER RH

    Tech Tips

    Use the same procedure described for the LH side.

  3. REMOVE REAR WHEEL

    Click here

  4. SEPARATE REAR WHEEL HOUSE LINER


    1. A01Q9FB

      Remove the 2 nuts and separate the rear wheel house liner.

  5. REMOVE REAR SPEED SENSOR


    1. Turn back the luggage compartment trim cover until the rear speed sensor connector can be seen.

    2. Disengage the rear speed sensor connector.

      A01QCB6C02
      *A for LH Side *B for RH Side
    3. A01QBR4C01
      *1 Pad Wear Indicator Wire
      *2 Rear Speed Sensor

      Disconnect the pad wear indicator wire connector from the rear speed sensor.

    4. Remove the 3 bolts and separate the rear speed sensor and 2 sensor clamps from the rear axle carrier sub-assembly and rear No. 2 upper control arm assembly.

      Note


      • Prevent foreign matter from attaching to the rear speed sensor tip.

      • Clean the speed sensor installation hole and the contact surfaces every time the rear speed sensor is removed.

    5. Turn back the rear wheel house liner until the grommet can be disengaged.

    6. A01QATV

      Remove the 2 nuts and 2 sensor clamps.

    7. Disengage the grommet and remove the rear speed sensor.