TIRE PRESSURE WARNING RECEIVER(for Luggage Compartment) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the tire pressure warning ECU and receiver (electrical key and TPMS receiver assembly) removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of tire pressure warning ECU and receiver (electrical key and TPMS receiver assembly) Transmitter ID registration When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates.

Click here

Initialization Tire pressure warning function

Click here

Note

When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

PROCEDURE


  1. REMOVE LUGGAGE COMPARTMENT TRIM INNER COVER RH

    Click here

  2. REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER (ELECTRICAL KEY AND TPMS RECEIVER ASSEMBLY)


    1. Disconnect the 2 connectors.

    2. Remove the bolt.

    3. A01Q8PX

      Disengage the 2 hooks to remove the tire pressure warning ECU and receiver (electrical key and TPMS receiver assembly).