REAR SHOCK ABSORBER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear shock absorber assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Rear wheel alignment adjustment

  1. Clear zero point calibration data and system information

  2. Perform yaw rate and acceleration sensor zero point calibration and store system information

  • VSC disabled or malfunctioning

  • DTCs are output

  • Slip indicator light illuminated

  • ABS warning light illuminated

  • Theft deterrent system (Tilt sensor)

Click here

Removal/installation of rear height control sensor sub-assembly Perform headlight control computer assembly LH initialization Headlight leveling function

Click here

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE LUGGAGE COMPARTMENT TRIM COVER

    Click here

  2. REMOVE REAR WHEEL

    Click here

  3. REMOVE REAR SUSPENSION ARM COVER

    Click here

  4. SEPARATE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY

    Click here

  5. SEPARATE REAR STEERING TIE ROD ASSEMBLY

    Click here

  6. SEPARATE REAR NO. 1 SUSPENSION ARM ASSEMBLY

    Click here

  7. REMOVE REAR STABILIZER LINK ASSEMBLY

    Click here

  8. SEPARATE REAR SHOCK ABSORBER ASSEMBLY (for Lower Side)

    Click here

  9. REMOVE REAR COIL SPRING

    Click here

  10. REMOVE REAR UPPER COIL SPRING INSULATOR

    Click here

  11. REMOVE REAR LOWER COIL SPRING INSULATOR

    Click here

  12. REMOVE REAR SHOCK ABSORBER ASSEMBLY (for Upper Side)


    1. A01QCF6

      Remove the 3 nuts and rear shock absorber assembly from the vehicle body.

  13. REMOVE REAR SUSPENSION SUPPORT ASSEMBLY


    1. A01Q8OV

      Using a 6 mm hexagon socket wrench, secure the rear shock absorber assembly rod and remove the rear support to rear shock absorber nut using a wrench.

      Note

      Securely insert the 6 mm hexagon socket wrench to the rear shock absorber assembly rod to prevent damage to the rear shock absorber assembly when removing the rear support to rear shock absorber nut.

    2. Remove the rear shock absorber cushion washer, rear No. 1 shock absorber cushion, rear suspension support assembly and rear No. 2 shock absorber cushion from the rear shock absorber assembly.

  14. REMOVE REAR NO. 1 SPRING BUMPER


    1. Remove the rear No. 1 spring bumper from the rear shock absorber assembly.