SUSPENSION CONTROL ECU INSTALLATION

PROCEDURE


  1. INSTALL ABSORBER CONTROL ECU


    1. B002CHT

      Install the absorber control ECU with the bolt and nut.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note


      • Avoid any impact to the absorber control ECU.

      • Do not drop the absorber control ECU. If it is dropped, replace it with a new one.

    2. Connect the 2 connectors.

    3. Return the floor carpet to its original position.

  2. INSTALL FRONT DOOR OPENING TRIM COVER RH

    Click here

  3. INSTALL FRONT DOOR SCUFF PLATE RH

    Click here

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note


    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

      Click here

    • After replacing the absorber control ECU, it is necessary to perform registration of vehicle identification information. Vehicle identification information is automatically acquired when the system enters test mode.

      Click here