DIFFERENTIAL MOUNT CUSHION INSTALLATION

PROCEDURE


  1. INSTALL REAR NO. 1 DIFFERENTIAL MOUNT CUSHION


    1. Using SST, install a new rear No. 1 differential mount cushion.

      B002D3OC02
      *a Turn *b Hold
      *c 0° +/- 3° *d Paint mark
      B002DP3 SST bolt lacation B002CU5 Front of the Vehicle
      B002CVE Top of the Vehicle - -
      SST
      09527-17011
      09570-24011

      Note


      • Make sure that the rear No. 1 differential mount cushion is aligned within 3° from the center.

      • Temporarily install the rear No. 1 differential mount cushion to the rear suspension member sub-assembly in order to prevent it from tilting, and then install SST.

      • Before using SST, apply grease to the SST bolts.

      • Be sure to use the correct combination of SST.

      • Make sure that SST (09527-17011) contacts the entire circumference of the rear No. 1 differential mount cushion.

      • Do not tilt the bolts of SST.

      • Tighten the 2 bolts of SST so that they enter the 2 holes of the rear No. 1 differential mount cushion by an equal amount.

      Tech Tips

      Install the 2 SST bolts to the 2 SST holes as shown in the illustration.

  2. INSTALL REAR NO. 2 DIFFERENTIAL MOUNT CUSHION


    1. Using SST, install a new rear No. 2 differential mount cushion.

      B002ECGC03
      *a SST bolt location *b 0° +/- 3°
      B002CU5 Front of the Vehicle - -
      SST
      09527-17011
      09570-24011

      Note


      • Make sure that the rear No. 2 differential mount cushion is aligned within 3° from the center.

      • Temporarily install the rear No. 2 differential mount cushion to the rear suspension member sub-assembly in order to prevent it from tilting, and then install SST.

      • Before using SST, apply grease to the SST bolt.

      • Be sure to use the correct combination of SST.

      • Make sure that SST (09527-17011) contacts the entire circumference of the rear No. 2 differential mount cushion.

      • Do not tilt the bolt of SST.

      Tech Tips

      Install the SST bolt to the SST hole as shown in the illustration.

  3. INSTALL TORQUE VECTORING DIFFERENTIAL FDU (FINAL DRIVE UNIT)

    Click here