COMBINATION SWITCH INSPECTION

PROCEDURE


  1. INSPECT COMBINATION SWITCH ASSEMBLY


    1. Inspect the TVD mode switch:


      1. A01QAUNC02
        *a

        Component without harness connected

        (Combination Switch Assembly)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        5 (TVD) - 4 (GND) TVD mode switch pushed and held Below 10 Ω
        TVD mode switch not pushed 10 kΩ or higher

        If the result is not as specified, replace the combination switch assembly.

    2. Check the illumination:


      1. A01Q9DKC01
        *A w/ Snow Switch
        *B w/o Snow Switch
        *a

        Component without harness connected

        (Combination Switch Assembly)
        *b Combination Switch Assembly Illumination

        Apply battery voltage to the combination switch assembly and check that the combination switch assembly illuminates.

        Standard
        Measurement Condition Specified Condition

        Battery positive (+) → 1 (ILL+)

        Battery negative (-) → 6 (ILL-)

        		 Illuminates

        If the result is not as specified, replace the combination switch assembly.