INJECTOR DRIVER INSTALLATION

PROCEDURE


  1. INSTALL INJECTOR DRIVER

    Note


    • Be careful not to drop or strike the injector driver.

    • The injector driver is grounded at the 4 bolts and 2 nuts. To ensure that it is grounded, clean the installation surfaces of the injector driver and engine before installing the injector driver.


    1. Temporarily install the 2 injector drivers with the 4 bolts and 2 nuts.

    2. Tighten the 4 bolts and 2 nuts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }
    3. B002COKC01
      *a Lock Lever
      *b Connector (with Lock)

      Connect the 2 injector driver connectors.

    4. Connect the 6 connectors (with lock) to the 2 injector drivers and move the lock lever to engage the lock of each connector (with lock) as shown in the illustration.

      Note

      Securely connect the connectors (with lock) to the injector driver and engage the lock.

  2. INSTALL V-BANK COVER SUB-ASSEMBLY

    Click here

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here