ENGINE COOLANT TEMPERATURE SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the engine coolant temperature sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of engine coolant temperature sensor Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

PROCEDURE


  1. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  2. REMOVE COOL AIR INTAKE DUCT SEAL

    Click here

  3. REMOVE CENTER NO. 4 ENGINE UNDER COVER

    Click here

  4. DRAIN ENGINE COOLANT

    Click here

  5. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. A01Q98L

      Disconnect the engine coolant temperature sensor connector.

    2. A01QA3VE01

      Using SST, remove the engine coolant temperature sensor from the front water by-pass joint.

      SST
      09817-33191

      Note

      If the engine coolant temperature sensor has been struck or dropped, replace it.

    3. Remove the gasket from the engine coolant temperature sensor.