HEATED OXYGEN SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the heated oxygen sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Gas leak from exhaust system is repaired Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

CAUTION:


  • A01Q8M9

    When the engine is hot, do not touch high-temperature areas such as the engine or exhaust pipe.

  • Touching high-temperature areas such as the engine and exhaust pipe could result in burns.

PROCEDURE


  1. REMOVE CONSOLE BOX ASSEMBLY

    Click here

  2. REMOVE HEATED OXYGEN SENSOR (for Bank 1)


    1. Turn back the floor carpet.

    2. A01Q8IU

      Disconnect the heated oxygen sensor connector.

    3. Disengage the clamp.

    4. A01Q9PNN01

      Disengage the heated oxygen sensor grommet from the vehicle body.

    5. Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.

      SST
      09224-00011

      Note

      If the heated oxygen sensor has been struck or dropped, replace it.

  3. REMOVE HEATED OXYGEN SENSOR (for Bank 2)


    1. Turn back the floor carpet.

    2. A01Q9KB

      Disconnect the heated oxygen sensor connector.

    3. Disengage the clamp.

    4. A01Q8R8N01

      Disengage the heated oxygen sensor grommet from the vehicle body.

    5. Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.

      SST
      09224-00011

      Note

      If the heated oxygen sensor has been struck or dropped, replace it.