BATTERY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the battery removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system

Click here

Lane departure alert system (w/ Steering Control)

Click here

Pre-crash safety system
Adaptive high beam system
Reset power trunk lid Power trunk lid system

Click here

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


    1. for LHD


      1. B002CAZC01
        B002C8N Remove in this Direction

        Disengage the 2 claws to open the battery terminal negative connector cover.

      2. B002EMX

        Loosen the nut and disconnect the cable from the negative (-) battery terminal.

        Note

        When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

        Click here

    2. for RHD


      1. B002EPKC01
        B002C8N Remove in this Direction

        Disengage the 2 claws to open the battery terminal negative connector cover.

      2. B002CG6

        Loosen the nut and disconnect the cable from the negative (-) battery terminal.

        Note

        When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

        Click here

  3. REMOVE BATTERY


    1. for LHD


      1. B002F20C01
        B002C8N Remove in this Direction

        Disengage the 2 claws to open the battery terminal connector cover.

      2. B002CYM

        Loosen the nut and disconnect the cable from the positive (+) battery terminal.

      3. Disengage the 2 clamps and disconnect the cable from the battery insulator.

      4. B002D04

        Remove the nut.

      5. Disengage the guide and remove the battery clamp sub-assembly from the battery carrier assembly.

      6. B002CK9

        Remove the battery insulator from the battery.

      7. B002ETM

        Remove the battery from the vehicle.

    2. for RHD


      1. B002D8LC01
        B002C8N Remove in this Direction

        Disengage the 4 claws to open the battery terminal connector cover.

      2. B002E7T

        Loosen the nut and disconnect the cable from the positive (+) battery terminal.

      3. Disengage the clamp and disconnect the cable from the battery insulator.

      4. B002CH4

        Remove the nut.

      5. Disengage the guide and remove the battery clamp sub-assembly from the battery carrier assembly.

      6. B002CFJ

        Remove the battery insulator from the battery.

      7. B002CU1

        Remove the battery from the vehicle.