PROPELLER SHAFT ASSEMBLY COMPONENTS
ILLUSTRATION
| *1 | FRONT NO. 1 FLOOR HEAT INSULATOR | *2 | NO. 1 FUEL TANK PROTECTOR |
| *3 | PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY | *4 | ADJUSTING WASHER |
 |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |  |
N*m (kgf*cm, ft.*lbf): Specified torque |
 |
Do not apply lubricants | - | - |
ILLUSTRATION
| *1 | NO. 1 CENTER SUPPORT BEARING ASSEMBLY | *2 | PROPELLER INTERMEDIATE SHAFT ASSEMBLY |
| *3 | SLIDING SHAFT BOOT | *4 | PROPELLER SHAFT ASSEMBLY |
| *5 | NO. 1 PROPELLER SHAFT DUST DEFLECTOR | *6 | NO. 2 PROPELLER SHAFT DUST DEFLECTOR |
| *7 | NO. 2 PROPELLER SHAFT DUST DEFLECTOR SNAP RING | *8 | ADJUSTING NUT |
| |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | * | For use with SST |
| ● | Non-reusable part |  |
Molybdenum disulphide lithium base NLGI No. 2 |