CRUISE CONTROL MAIN SWITCH REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the cruise control main switch removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedure	Effect/Inoperative when not Performed	Link
Disconnect cable from negative battery terminal	Memorize steering angle neutral point	Parking assist monitor system	Click here
		LKA/LDA system	Click here
		Pre-crash safety system
		Adaptive high beam system
	Reset power trunk lid	Power trunk lid system	Click here

Tech Tips

Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.

PROCEDURE

REMOVE HORN BUTTON ASSEMBLY

Click here
REMOVE CRUISE CONTROL MAIN SWITCH
1. Remove the 2 screws.
2. Remove in this Direction
  
  Disconnect the connector and remove the cruise control main switch as shown in the illustration.