DYNAMIC RADAR CRUISE CONTROL SYSTEM Cruise SET Indicator Light Circuit

DESCRIPTION


CAUTION / NOTICE / HINT

Note

When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in the driving support ECU assembly will not match the information from the vehicle. As a result, a DTC may be stored.

PROCEDURE


  1. PERFORM ACTIVE TEST USING GTS (INDICAT. SET)


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

    5. Perform "Active Test" according to the display on the GTS.


      Body Electrical > Combination Meter > Active Test
      Tester Display Measurement Item Control Range Diagnostic Note
      Indicat. SET Cruise control SET indicator ON or OFF -

      Body Electrical > Combination Meter > Active Test
      Tester Display
      Indicat. SET
      OK
      The cruise control SET indicator comes on or goes off.
      Result
      Proceed to
      OK
      NG

    NG

    GO TO METER / GAUGE SYSTEM Click here

    OK

  2. READ VALUE USING GTS (SET/COAST SWITCH)


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Radar Cruise / Data List.

    5. Read the Data List according to the display on the GTS.


      Powertrain > Radar Cruise > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      SET/COAST Switch -/SET switch signal ON or OFF

      ON: -/SET switch on

      OFF: -/SET switch off

      		 -

      Powertrain > Radar Cruise > Data List
      Tester Display
      SET/COAST Switch
      OK
      When the cruise control main switch (-/SET switch) is operated, the display changes as shown above.
      Result
      Result Proceed to
      The cruise control SET indicator illuminates and turns off according to the operation of the cruise control main switch (-SET switch). A
      The cruise control SET indicator does not illuminate but the Data List item -SET Switch changes according to the operation of the cruise control main switch (-SET switch). B
      The cruise control SET indicator does not illuminate and the Data List item -SET Switch does not change according to the operation of the cruise control main switch (-SET switch). C

    A

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    B

    REPLACE COMBINATION METER ASSEMBLY Click here

    C

    REPLACE DRIVING SUPPORT ECU ASSEMBLY Click here