THERMOSTAT REMOVAL

CAUTION / NOTICE / HINT

Note

When the oil cooler assembly (for air cooled type) has been removed/installed or the oil cooler hose sub-assembly has been disconnected/reconnected, check the engine oil level after warming up the engine oil to between 100°C (212°F) and 120°C (248°F) to open the thermostat between the engine and oil cooler assembly (for air cooled type).

B002C8GC06
*1 Thermostat (Thermostat Housing Assembly) *2 Oil Cooler Hose Sub-assembly
*3 Oil Cooler Assembly (for Air Cooled Type) - -

Tech Tips

Enter the following menus: Powertrain / Engine / Data List / Engine Oil Temperature Sensor.


Powertrain > Engine > Data List
Tester Display
Engine Oil Temperature Sensor

PROCEDURE


  1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

    Click here

  2. DRAIN ENGINE OIL

    Click here

  3. REMOVE OIL THERMOSTAT HOUSING ASSEMBLY


    1. B002DAG

      Remove the 2 bolts and disconnect the oil cooler hose sub-assembly.

    2. B002D8V

      Remove the 2 O-rings from the oil cooler hose sub-assembly.

    3. B002ENYC02
      *1 Oil Thermostat Housing Assembly
      *2 Oil Cooler Assembly
      B002DP3 Oil Cooler Union Bolt
      B002CU5 Bolt

      Remove the oil cooler union bolt and gasket.

    4. Remove the bolt, separate the oil cooler assembly and then remove the oil thermostat housing assembly.

    5. A01QCY4

      Remove the O-ring from the oil thermostat housing assembly.

    6. A01Q94W

      Remove the O-ring from the oil cooler assembly.