OIL PRESSURE SWITCH INSTALLATION

PROCEDURE


  1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY


    1. A01XQUVC07
      *a Adhesive 1324
      *b Oil Inlet Port

      Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

      Note


      • Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.

      • To prevent contamination by foreign matter, install immediately after applying adhesive.

    2. A01XRICC01
      *a Torque Wrench Fulcrum Length

      Using SST, install the engine oil pressure switch assembly.

      SST
      09922-10010
      Torque:
      Specified tightening torque
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine within 1 hour of installation.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using SST (fulcrum length of 135 mm (5.31 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)): 8.2 N*m (84 kgf*cm, 73 in.*lbf)

    3. Connect the engine oil pressure switch assembly connector.

  2. INSTALL OIL TEMPERATURE SENSOR

    Click here

  3. INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY

    Click here