STARTER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the starter assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system

Click here

Lane departure alert system (w/ Steering Control)

Click here

Pre-crash safety system
Adaptive high beam system
Reset power trunk lid Power trunk lid system

Click here

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH

    Click here

  4. REMOVE NO. 3 EXHAUST MANIFOLD HEAT INSULATOR


    1. B002DO0

      Remove the 3 bolts and No. 3 exhaust manifold heat insulator.

  5. REMOVE STARTER ASSEMBLY


    1. B002DD1C01
      *1 Terminal Cover

      Disconnect the starter assembly connector.

    2. Open the terminal cover.

    3. Remove the 2 nuts and disconnect engine wire.

    4. B002E1G

      Remove the 2 bolts and starter assembly.

  6. REMOVE FLYWHEEL HOUSING SIDE COVER


    1. B002D5B

      Remove the flywheel housing side cover.