PCV VALVE REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the PCV valve (ventilation valve sub-assembly) removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system

Click here

LKA/LDA system

Click here

Pre-crash safety system
Adaptive high beam system
Reset power trunk lid Power trunk lid system

Click here

PROCEDURE


  1. REMOVE INTAKE AIR SURGE TANK ASSEMBLY

    Click here

  2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here

  3. REMOVE PCV VALVE (VENTILATION VALVE SUB-ASSEMBLY)


    1. B002CDQ

      Slide the clip and disconnect the ventilation hose from the PCV valve (ventilation valve sub-assembly).

    2. B002EGF

      Remove the PCV valve (ventilation valve sub-assembly) from the case separator.