AUTOMATIC TRANSMISSION REAR OIL SEAL REPLACEMENT

PROCEDURE


  1. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY

    Click here

  2. REMOVE AUTOMATIC TRANSMISSION FLANGE YOKE ASSEMBLY


    1. A01XQUIN03

      Using SST and a hammer, release the staked part of the lock nut.

      SST
      09930-00010

      Note


      • Use SST with the tapered part facing the shaft.

      • Do not modify the tip of SST with a grinder or other device.

      • Completely release the staked part of the lock nut before removing it.

      • Do not damage the threads of the shaft.

    2. A01XQ47C03
      *a Hold
      *b Turn

      Using SST and a 30 mm deep socket wrench, remove the lock nut.

      SST
      09330-00021
      09950-30012   ( 09955-03040 )

    3. Remove SST.

    4. Tap the automatic transmission flange yoke assembly with a plastic hammer to remove it.

    5. A01XR6YC01
      *1 Oil Seal

      Using a screwdriver, remove the oil seal from the automatic transmission flange yoke assembly.

      Note

      Do not damage the automatic transmission flange yoke assembly.

  3. REMOVE AUTOMATIC TRANSMISSION REAR OIL SEAL


    1. A01XQ69N07

      Using SST, remove the automatic transmission rear oil seal.

      SST
      09308-00010

  4. INSTALL AUTOMATIC TRANSMISSION REAR OIL SEAL


    1. Coat the lip of a new automatic transmission rear oil seal with MP grease.

    2. A01XQ73C02
      *a Depth

      Using SST and a hammer, install the automatic transmission rear oil seal.

      SST
      09316-12010
      09316-60011   ( 09316-00011, 09316-00041 )
      Standard Depth
      3.3 to 3.7 mm (0.130 to 0.146 in.)

  5. INSTALL AUTOMATIC TRANSMISSION FLANGE YOKE ASSEMBLY


    1. Coat the lip of a new oil seal with MP grease.

    2. B002DLCC01
      *a Depth

      Using SST and a hammer, install the oil seal.

      SST
      09517-36010
      Standard Depth
      0 to 0.3 mm (0 to 0.0118 in.)

    3. Install the automatic transmission flange yoke assembly.

    4. A01XQCCC03
      *a Hold
      *b Turn

      Using SST and a 30 mm deep socket wrench, install a new lock nut.

      SST
      09330-00021
      09950-30012   ( 09955-03040 )
      Torque:
      135 N*m  { 1377 kgf*cm, 100 ft.*lbf }

    5. Using a chisel and hammer, securely stake the lock nut.

  6. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY

    Click here