SHIFT PADDLE SWITCH REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the shift paddle switch (transmission shift switch assembly) removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system

Click here

LKA/LDA system

Click here

Pre-crash safety system
Adaptive high beam system
Reset power trunk lid Power trunk lid system

Click here

Note

Do not rotate the spiral cable without the steering wheel assembly with the battery connected and the engine switch on (IG).

PROCEDURE


  1. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  2. REMOVE CRUISE CONTROL MAIN SWITCH (w/ Lane Departure Alert System)

    Click here

  3. REMOVE STEERING PAD SWITCH ASSEMBLY (w/ Lane Departure Alert System)

    Click here

  4. REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) (w/o Lane Departure Alert System)


    1. B002DGQ

      Disconnect the No. 1 switch wire connector.

    2. B002EB6

      Remove the 4 screws, and disconnect the 2 shift paddle switches (transmission shift switch assemblies) from the steering wheel assembly.

    3. B002CWX

      Disengage the 5 guides to remove the 2 shift paddle switches (transmission shift switch assemblies) with No. 1 switch wire from the steering wheel assembly.

    4. B002D82

      Disconnect the 2 shift paddle switch (transmission shift switch assembly) connectors to remove the 2 shift paddle switches (transmission shift switch assemblies) from the No. 1 switch wire.

  5. REMOVE NO. 2 SWITCH WIRE (w/o Lane Departure Alert System)

    Tech Tips

    There is no need to remove this unless the No. 2 switch wire is replaced.


    1. B002DSP

      Disengage the No. 2 switch wire connector clamp from the steering wheel assembly.

    2. B002COG

      Disengage the 2 guides to remove the No. 2 switch wire from the steering wheel assembly.

  6. REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) (w/o Lane Departure Alert System)


    1. B002EHY

      Disengage the guide to disconnect the No. 1 switch wire from the steering wheel assembly.

    2. Disconnect the No. 1 switch wire connector.

    3. B002C6G

      Remove the 4 screws, and disconnect the 2 shift paddle switches (transmission shift switch assemblies) from the steering wheel assembly.

    4. B002EZ7

      Disconnect the 2 shift paddle switch (transmission shift switch assembly) connectors to remove the 2 shift paddle switches (transmission shift switch assemblies) from the No. 1 switch wire.

    5. B002EE3

      Disengage the 6 guides to remove the 2 shift paddle switches (transmission shift switch assemblies) with No. 1 switch wire from the steering wheel assembly.