COMBINATION SWITCH INSPECTION

PROCEDURE


  1. INSPECT COMBINATION SWITCH ASSEMBLY


    1. A01XPYMC12
      *A w/ SNOW Switch
      *a

      Component without harness connected

      (Combination Switch Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      7 (P) - 4 (GND) Mode switch being turned and held at SPORT position Below 10 Ω
      Mode switch not turned 10 kΩ or higher
      3 (B) - 4 (GND) Mode switch being pushed and held Below 10 Ω
      Mode switch not pushed 10 kΩ or higher
      2 (2ND) - 4 (GND) SNOW switch pushed and held Below 10 Ω
      SNOW switch not pushed 10 kΩ or higher

      If the result is not as specified, replace the combination switch assembly.