BLACK OUT TAPE(for Rear Door) INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. REPAIR INSTRUCTION

   Click here

2. INSTALL REAR DOOR OUTSIDE STRIPE

   
   

   1. Refer to the illustration to position a new rear door outside stripe.

      

      *A	LH Side	*B	RH Side
      *a	Point A	*b	Point B
      *c	Edge of Curved Surface	*d	Straight
      *e	Triangle	-	-

      Standard Measurement
      Area Measurement Area Measurement A 1.0 mm (0.0394 in.) B 10.0 mm (0.394 in.) C 1.0 mm (0.0394 in.) D 2.5 mm (0.0984 in.)

   2. Remove the release paper and install the rear door outside stripe.

      Tech Tips

      Align the point (B) on the rear door outside stripe with the point (A) on the door frame and install the rear door outside stripe.

3. INSTALL REAR DOOR LOWER OUTSIDE STRIPE

   
   

   1. Refer to the illustration to position a new rear door lower outside stripe.

      

      *A	LH Side	*B	RH Side
      *a	Point A	*b	Point B
      *c	Edge of Curved Surface	*d	Straight
      *e	Triangle	-	-

      Standard Measurement
      Area Measurement Area Measurement A 10.0 mm (0.394 in.) B 5.0 mm (0.197 in.) C -1.0 to 1.0 mm (-0.0394 to 0.0394 in.) D 1.0 mm (0.0394 in.)

   2. Remove the release paper and install the rear door lower outside stripe.

      Tech Tips

      Align the point (B) on the rear door lower outside stripe with the point (A) on the door frame and install the rear door lower outside stripe.

4. INSTALL REAR DOOR QUARTER WINDOW GLASS

   Click here

5. INSTALL REAR DOOR GLASS RUN

   Click here

6. INSTALL REAR DOOR FRAME GARNISH

   Click here

7. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

   Click here

8. INSTALL REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY

   Click here

9. INSTALL REAR DOOR WEATHERSTRIP

   Click here

10. INSTALL REAR DOOR SERVICE HOLE COVER

    Click here

11. INSTALL REAR DOOR BELT SEAL

    Click here

12. INSTALL REAR DOOR GLASS INNER WEATHERSTRIP

    Click here

13. INSTALL REAR DOOR BELT REAR SEAL

    Click here

14. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

15. INSTALL REAR DOOR REAR FRAME BRACKET

    Click here

16. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE UPPER PANEL

    Click here

17. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

18. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

19. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

20. INSPECT POWER WINDOW OPERATION

    Click here