WHEEL OPENING MOULDING(for Rear) REASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL NO. 1 BODY OUTSIDE MOULDING PAD

    Tech Tips

    When installing the No. 1 body outside moulding pad, heat the quarter outside moulding using a heat light.

    Standard
    Item Temperature
    Quarter Outside Moulding 20 to 30°C (68 to 86°F)

    Note

    Do not heat the quarter outside moulding excessively.


    1. Clean the No. 1 body outside moulding pad installation surface with a non-residue solvent.

    2. Apply primer to the No. 1 body outside moulding pad installation area on the quarter outside moulding.

      Note

      Apply primer evenly so that there are no uncoated areas.

    3. Remove the peeling paper on a new No. 1 body outside moulding pad while making sure not to touch the adhesive surface.

    4. A005MMHC01
      *1 Mark-off Line
      *a 5.0 mm (0.197 in.)
      *b 2.0 mm (0.0787 in.)
      *c 8.0 mm (0.315 in.)
      *d 1.6 mm (0.0630 in.)

      Install a No. 1 body outside moulding pad in the position shown in the illustration.

      Note


      • Press the double-sided tape on the No. 1 body outside moulding pad firmly to attach.

      • After the primer dries (3 minutes or more), install the No. 1 body outside moulding pad.

      • After applying primer, reapply primer after 24 hours elapse.