WHEEL OPENING MOULDING(for Front) REMOVAL

Info Added 2017-10-06

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY


    1. Remove the 3 clips and 5 screws.

      A005MUN
    2. B0048PVC01
      B0048V2 Protective Tape

      Apply protective tape around the front fender moulding sub-assembly.

    3. B0048JKC01
      *1 Pin Hold Clip
      *a 90 deg

      Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    4. B0048HAC01
      B0048JB Place Hand Here
      B0048R7 Remove in this Direction (1)
      B0048O3 Remove in this Direction (2)

      Pull back the edge of the front fender liner and disengage the claws by pushing the area indicated by the arrow in the illustration with a finger.

      Note


      • Do not apply excessive force when pulling back the front fender liner.

      • To avoid damaging the claws, do not forcibly pull the front fender moulding sub-assembly.

    5. B0048PXC01
      B0048JB Place Hand Here
      B0048R7 Remove in this Direction

      Disengage the clips to remove the front fender moulding sub-assembly as shown in the illustration.