REAR DOOR BELT MOULDING INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL REAR DOOR BELT MOULDING ASSEMBLY

   
   

   1. 

      Install in this Direction

      Engage the claws to install a new rear door belt moulding assembly as shown in the illustration.

   2. Remove the protective tape.

2. INSTALL REAR DOOR QUARTER WINDOW GLASS

   Click here

3. INSTALL REAR DOOR GLASS RUN

   Click here

4. INSTALL REAR DOOR FRAME GARNISH

   Click here

5. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

   Click here

6. INSTALL REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY

   Click here

7. INSTALL REAR DOOR SERVICE HOLE COVER

   Click here

8. CONNECT REAR DOOR WEATHERSTRIP

   
   

   1. Connect the rear door weatherstrip.

9. INSTALL REAR DOOR BELT SEAL

   Click here

10. INSTALL REAR DOOR GLASS INNER WEATHERSTRIP

    Click here

11. INSTALL REAR DOOR BELT REAR SEAL

    Click here

12. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

13. INSTALL REAR DOOR REAR FRAME BRACKET

    Click here

14. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE UPPER PANEL

    Click here

15. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

16. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

17. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

18. INSPECT POWER WINDOW OPERATION

    Click here