HORN REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the low pitched horn removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link
Front bumper assembly Change grille shutter control modes and/or perform initialization (w/ Exhaust Heat Recirculation System) Grille Shutter system

Click here

PROCEDURE


  1. REMOVE FRONT BUMPER ASSEMBLY

    Click here

  2. REMOVE NO.1 RADIATOR GRILLE RETAINER

    Click here

  3. REMOVE NO.1 RADIATOR TO SUPPORT SEAL

    Click here

  4. REMOVE LOW PITCHED HORN ASSEMBLY


    1. A005MSZ

      Disconnect the connector.

    2. Remove the bolt and low pitched horn assembly.