HEIGHT CONTROL SENSOR INSPECTION

PROCEDURE


  1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


    1. Preparation for check


      1. Confirm the standard, high and low positions of the link that will be used in the following inspection.


        • The standard position is 58° from the maximum link angle (high) and 51° from the maximum link angle (low).

        • The high position (+33.85°) is 24.15° from the maximum link angle (high).

        • The low position (-33.85°) is 17.15° from the maximum link angle (low).

        A005MN3C01
        *a Standard Position *b Maximum Link Angle (Low)
        *c Maximum Link Angle (High) *d 51°
        *e 58° *f -33.85°
        *g +33.85° - -

      2. Connect 3 dry cell batteries (1.5 V) in series.

        Note

        Do not use rechargeable batteries as they may not output a voltage of 1.5 V.

      3. Connect a positive (+) lead from the batteries to terminal 3 (SHB) and a negative (-) lead to terminal 1 (SHG).

        A005MMPC01
        *a

        Component without harness connected

        (Rear Height Control Sensor Sub-assembly LH)

        		 *b Low
        *c Standard Position *d High
        *e -33.85° *f +33.85°

      4. Measure the voltage between terminals 2 (SHRL) and 1 (SHG) while slowly moving the link up and down.

        Standard Voltage
        Tester Connection Condition Specified Condition
        1 (SHG) - 2 (SHRR) +33.85° (High) 4.15 V
        1 (SHG) - 2 (SHRR) 0° (Standard position) 2.5 V
        1 (SHG) - 2 (SHRR) -33.85° (Low) 1.04 V

        If the result is not as specified, replace the rear height control sensor sub-assembly LH.