HEADLIGHT DIMMER SWITCH REMOVAL

Info Added 2017-10-06

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the headlight dimmer switch assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Simple intelligent parking assist system*1
Toyota parking assist-sensor system*1
Pre-collision system
Initialize back door lock Power door lock control system

Click here

Removal/installation of the spiral cable with sensor sub-assembly Steering angle neutral point (Initialize panoramic view monitor system)

  • Simple Intelligent Parking Assist System

  • Toyota parking assist-sensor system (w/Simple Intelligent Parking Assist System)

Click here

*1: When performing learning using the GTS.

Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

B0048SV

Click here

PROCEDURE


  1. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Click here

  2. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

    Click here

  3. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY


    1. A001RCIC01
      B0048R7 Remove in this Direction

      Disconnect the connector.

    2. Disengage the claws to remove the headlight dimmer switch assembly as shown in the illustration.