HEADLIGHT ASSEMBLY(for LED Headlight) REMOVAL

Info Added 2017-10-06

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the headlight assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Headlight ECU sub-assembly LH

  • Synchronize vehicle information

  • Initialize headlight ECU sub-assembly LH

 Automatic headlight beam level control system

Click here

Note

If the headlight assembly RH is replaced with a new one, vehicle information registration and initialization are not necessary.

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE FRONT BUMPER ASSEMBLY

    Click here

  2. REMOVE HEADLIGHT ASSEMBLY


    1. A005O7EC02
      B0048V2 Protective Tape

      Apply protective tape around the headlight assembly as shown in the illustration.

    2. A005NEPC01
      *a Connector Lock Lever
      B0048R7 Remove in this Direction

      Disengage the claw, pull down the connector lock lever as shown in the illustration to disconnect the connector.

    3. A005MW0

      Remove the bolt and 3 screws.

    4. A005O52C02
      B0048R7 Remove in this Direction

      Remove the headlight assembly as shown in the illustration.