REAR WIPER MOTOR INSTALLATION

Info Added 2017-10-06

PROCEDURE


  1. INSTALL REAR WIPER MOTOR ASSEMBLY


    1. Install the rear wiper motor assembly with the 3 bolts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    2. Connect the connector.

  2. INSTALL REAR WIPER MOTOR GROMMET


    1. A005MLHC02
      *a Rear Wiper Motor Grommet Lip

      Apply MP grease to the entire surface of the rear wiper motor grommet lip.

      Tech Tips

      Make sure that the hole does not get clogged with grease and the grooves on the lip are filled with grease.

    2. A005NAXC02
      *a Alignment Mark

      Install the rear wiper motor grommet.

      Tech Tips

      Install the rear wiper motor grommet with its alignment mark facing up.

  3. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY


    1. A005NFYC02
      *a Serration

      When reusing the rear wiper arm and blade assembly:


      1. Clean the wiper arm serrations to remove any burrs, dirt, etc.

        Note

        Do not grind down the wiper arm serrations.

    2. When reusing the rear wiper motor assembly:


      1. Clean the wiper pivot serrations with a wire brush.

    3. Turn the power switch on (IG).

    4. Operate the rear wiper motor assembly and stop it at the automatic stop position.

    5. Turn the power switch off.

    6. A005NOBC04
      *a Alignment Mark

      Install the rear wiper arm and blade assembly with the nut to the position shown in the illustration.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

      Tech Tips

      Hold the rear wiper arm by hand while tightening the nut.

      Reference Measurement
      Area Measurement
      A 10.0 mm (0.394 in.)

    7. Turn the power switch on (IG).

    8. Operate the rear wiper while spraying washer fluid onto the back door glass. Make sure that the rear wiper functions properly and the wiper does not contact the vehicle body.

    9. Turn the power switch off.

    10. Lift the wiper arm twice after the wiper stops and check the wiper set position.

    11. A005MM8C01
      B0048R7 Remove in this Direction (1)
      B0048O3 Remove in this Direction (2)

      Engage the claws and guides to close the rear wiper arm head cap as shown in the illustration.

    12. A005NV7

      Slide the rear wiper arm head cap to engage the claws as shown in the illustration.

  4. INSTALL BACK DOOR TRIM PANEL ASSEMBLY

    Click here

  5. INSTALL BACK DOOR SIDE GARNISH LH

    Click here

  6. INSTALL BACK DOOR SIDE GARNISH RH

    Tech Tips

    Use the same procedure as for the LH side.

  7. INSTALL BACK DOOR TRIM UPPER PANEL ASSEMBLY

    Click here