OUTER REAR VIEW MIRROR GLASS INSPECTION

PROCEDURE


  1. INSPECT OUTER MIRROR LH


    1. A001RFWC02
      *a

      Component without harness connected

      (Outer Mirror LH)

      Check the resistance.


      1. Measure the resistance according the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 - 2 25°C (77°F) 8.5 to 11.5 Ω

        If the result is not as specified, replace the outer mirror LH.

    2. A001P9QC03
      *a

      Component without harness connected

      (Outer Mirror LH)

      Check the operation of the outer rear view mirror indicator. (w/ Blind Spot Monitor System)

      Note

      Do not apply a voltage of more than 6 V.


      1. Connect 4 new 1.5 V dry-cell batteries in series.

      2. Apply 6 V battery voltage to the terminals of the connector, and check that the outer rear view mirror indicator comes on.

        OK
        Tester Connection Specified Condition

        6 V battery positive (+) → Terminal 1

        6 V battery negative (-) → Terminal 2

        		 Outer rear view mirror indicator comes on

        If the result is not as specified, replace the outer mirror LH.

  2. INSPECT OUTER MIRROR RH


    1. A001QVZC03
      *a

      Component without harness connected

      (Outer Mirror RH)

      Check the resistance.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 - 2 25°C (77°F) 8.5 to 11.5 Ω

        If the result is not as specified, replace the outer mirror RH.

    2. A001QLWC03
      *a

      Component without harness connected

      (Outer Mirror RH)

      Check the operation of the outer rear view mirror indicator. (w/ Blind Spot Monitor System)

      Note

      Do not apply a voltage of more than 6 V.


      1. Connect 4 new 1.5 V dry-cell batteries in series.

      2. Apply 6 V battery voltage to the terminals of the connector, and check that the outer rear view mirror indicator comes on.

        OK
        Tester Connection Specified Condition

        6 V battery positive (+) → Terminal 1

        6 V battery negative (-) → Terminal 2

        		 Outer rear view mirror indicator comes on

        If the result is not as specified, replace the outer mirror RH.