OUTER REAR VIEW MIRROR GLASS REMOVAL

Info Added 2017-10-06

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE OUTER MIRROR


    1. A001PLAC01
      B0048V2 Protective Tape
      B0048R7 Remove in this Direction

      Apply protective tape to the area as shown in the illustration.

    2. Push the upper part of the mirror surface and tilt it.

    3. Using a moulding remover A, disengage the claws on the lower part of the outer mirror as shown in the illustration.

      Note

      Do not push the outer mirror with excessive force. Doing so may cause the actuator to come off or break the mirror surface.

      Tech Tips

      If excessive force is used when pressing down the mirror surface, the claws will engage again.

    4. Push the lower part of the mirror surface and tilt it.

      Tech Tips

      If excessive force is used when pressing down the mirror surface, the claws will engage again.

    5. A001PFXC01
      B0048V2 Protective Tape
      B0048R7 Remove in this Direction

      Using a moulding remover A, disengage the claws on the upper part of the outer mirror as shown in the illustration.

      Note

      Do not push the outer mirror with excessive force. Doing so may cause the actuator to come off or break the mirror surface.

      Tech Tips

      If excessive force is used when pressing down the mirror surface, the claws will engage again.

    6. w/ Blind Spot Monitor:


      1. A001O6Z

        Disconnect the connector.

    7. A001QIO

      Disconnect the 2 connectors to remove the outer mirror.