POWER WINDOW REGULATOR MOTOR(for Rear Door) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY


    1. Apply MP grease to the sliding and rotating areas of the power window regulator motor assembly.

    2. Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      Tech Tips

      When replacing a power window regulator motor assembly, a new power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

  2. INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY

    Click here

  3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

    Click here

  4. INSTALL REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY

    Click here

  5. INSTALL REAR DOOR GLASS RUN

    Click here

  6. INSTALL REAR DOOR FRAME GARNISH

    Click here

  7. INSTALL REAR DOOR SERVICE HOLE COVER

    Click here

  8. INSTALL REAR DOOR BELT REAR SEAL

    Click here

  9. INSTALL REAR DOOR BELT SEAL

    Click here

  10. INSTALL REAR DOOR GLASS INNER WEATHERSTRIP

    Click here

  11. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  12. INSTALL REAR DOOR REAR FRAME BRACKET

    Click here

  13. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE UPPER PANEL

    Click here

  14. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  15. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  16. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

  17. INSPECT POWER WINDOW OPERATION

    Click here