POWER WINDOW REGULATOR MOTOR(for Front Door) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY


    1. Apply MP grease to the sliding and rotating areas of the power window regulator motor assembly.

    2. Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      Tech Tips

      When replacing a power window regulator motor assembly, a new power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

  2. INSTALL FRONT DOOR WINDOW REGULATOR ASSEMBLY

    Click here

  3. INSTALL NO. 2 FRONT DOOR SERVICE HOLE COVER

    Click here

  4. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

    Click here

  5. INSTALL FRONT DOOR SERVICE HOLE COVER

    Click here

  6. INSTALL FRONT DOOR BELT SEAL

    Click here

  7. INSTALL FRONT DOOR GLASS INNER WEATHERSTRIP

    Click here

  8. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  9. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Front Passenger Side)

    Click here

  10. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Driver Side)

    Click here

  11. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  12. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  13. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

  14. INSPECT POWER WINDOW OPERATION

    Click here