REAR CROSSING TRAFFIC ALERT BUZZER REMOVAL

Info Added 2017-10-06

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the blind spot monitor buzzer removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedures	Effect/Inoperative when not Performed	Link
Disconnect cable from negative auxiliary battery terminal	Memorize steering angle neutral point	Lane departure alert system (w/ Steering Control)	Click here
		Simple intelligent parking assist system*1
		Toyota parking assist-sensor system*1
		Pre-collision system
	Initialize back door lock	Power door lock control system	Click here

*1: When performing learning using the GTS.

Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here

Note

If the front seat airbag assembly has been deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.

Tech Tips

Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.

PROCEDURE

REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for LHD with Driver Side Knee Airbag)

Click here
REMOVE FUSE BOX OPENING COVER (for LHD without Driver Side Knee Airbag)

Click here
REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (for RHD)

Click here
REMOVE BLIND SPOT MONITOR BUZZER
1. for LHD:
  1. Using a clip remover, disengage the clamp.
  2. Disconnect the connector to remove the blind spot monitor buzzer.
2. for RHD:
  1. Using a clip remover, disengage the clamp.
  2. Disconnect the connector to remove the blind spot monitor buzzer.