TOYOTA PARKING ASSIST-SENSOR SYSTEM CALIBRATION

Note

When any of the following parts have been replaced, perform adjustment shown in the following table. If not, the TOYOTA parking assist-sensor system may not operate correctly.


  1. ADJUST TOYOTA PARKING ASSIST-SENSOR SYSTEM


    1. The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during TOYOTA parking assist-sensor system removal/installation are shown below.

      Part Name Operation Adjustment Item Proceed to
      Steering sensor

      • Removal and installation of the steering sensor

      • Removal and installation of the connector of the steering sensor

      • Replacement

      		 Steering angle neutral point (Initialize simple intelligent parking assist system)*

      Click here

      Clearance warning ECU assembly Replacement Steering angle neutral point

      Click here

      Bumper type registration
      Auxiliary battery Disconnect the cable from the negative (-) auxiliary battery terminal, or remove the fuse for the TOYOTA parking assist-sensor system, etc. ("System Unavailable" is displayed on the multi-informationdisplay) Steering angle neutral point*

      Click here


      • *: The steering sensor zero point can also be calibrated by driving the vehicle.

        Click here