SIMPLE INTELLIGENT PARKING ASSIST SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / IPA/ICS/Clearance Sonar / Data List.

    5. Read the Data List according to the display on the GTS.


      Body Electrical > IPA/ICS/Clearance Sonar > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      IPA System Existence of simple intelligent parking assist system Without, With or Unfixed

      Without: w/o Simple Intelligent Parking Assist System

      With: w/ Simple Intelligent Parking Assist System

      Unfixed: Unknown

      		 -
      Parking Signal Parking signal OFF or ON

      OFF: Shift state other than park (P) selected

      ON: Park (P) selected

      		 -
      Reverse Signal Reverse signal OFF or ON

      OFF: Shift state other than reverse (R) selected

      ON: Reverse (R) selected

      		 -
      IPA Switch IPA main switch assembly signal OFF or ON

      ON: IPA main switch assembly on

      OFF: IPA main switch assembly off

      		 -
      Steering Wheel Location Location of the steering wheel Right, Left or Unfixed

      Right: RH side

      Left: LH side

      Unfixed: Unknown

      		 -
      HV System Existence of hybrid system Without, With or Unfixed

      Without: w/o Hybrid system

      With: w/ Hybrid system

      Unfixed: Unknown

      		 -
      History of IPA Cancel due to Lo Power Abnormality history (The simple intelligent parking assist system was canceled or did not start operating due to low clearance warning ECU assembly IG power source voltage.) Unrec/Rec*1 Unrec *2
      Bumper Type Registered bumper type Unfixed or 1 to 127

      1: Standard

      2 to 127: Unknown

      Unfixed: Unknown

      		 -
      # Codes Number of stored DTCs min.: 0, max.: 255 Number of DTCs will be displayed -

      • *1: If the IG power source voltage of the clearance warning ECU assembly dropped while the simple intelligent parking assist system was operating or was low when the IPA main switch assembly was pressed to operate the simple intelligent parking assist system, "Rec" is displayed.

      • *2: Clearing the DTCs will reset the abnormality history.

        Click here

  2. ACTIVE TEST

    Tech Tips

    Using the GTS to perform Active Tests allows relays, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

    5. Perform the Active Test by referring to the table below.


      Body Electrical > Combination Meter > Active Test
      Tester Display Measurement Item Control Range Diagnostic Note
      Intelligent Parking Assist Indicator Combination Meter Assembly (Illuminates the S-IPA indicator light) S-IPA indicator light on/off -