FRONT DOOR SPEAKER INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY


    1. A001Q3K

      Engage the claw and guide to temporarily install the front No. 1 speaker assembly.

    2. Using an air riveter or a hand riveter, install the front No. 1 speaker assembly with 3 new rivets order show in the illustration.

      A001RYSC02
      *a Incorrect *b Correct
      *c Riveter *d Mandrel

      Note


      • Do not touch the speaker cone.

      • Do not pry on the rivets with the riveter, as this will cause damage to the riveter and mandrel.

      • Confirm that the rivets are seated properly against the speaker.

      • Do not tilt the riveter when installing the speaker with the rivets.

      • Do not leave any space between the rivet heads and speaker.

      • Do not leave any space between the speaker and door. Firmly hold the speaker and door together while installing the rivets.

      Tech Tips

      If the mandrel of the rivet does not come off on the first operation of the rivet gun, slide the rivet gun forward on the mandrel and operate it again.

    3. Connect the connector.

  2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  3. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Driver Side)

    Click here

  4. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Front Passenger Side)

    Click here

  5. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here