RADIO RECEIVER(for Radio and Display Type) REMOVAL

Info Added 2017-10-06

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY

    Click here

  2. REMOVE INSTRUMENT CLUSTER FINISH LOWER CENTER PANEL SUB-ASSEMBLY

    Click here

  3. REMOVE INSTRUMENT PANEL CENTER REGISTER ASSEMBLY

    Click here

  4. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET


    1. B0048OK

      Remove the 4 screws.

    2. B0048M0C01
      B0048R7 Remove in this Direction

      Pull the radio and display receiver assembly with bracket toward the rear of the vehicle to disengage the claws and clips as shown in the illustration.

    3. Disconnect each connector and remove the radio and display receiver assembly with bracket.

  5. REMOVE NO. 1 RADIO RECEIVER BRACKET


    1. B0048IT

      Remove the 2 screws and No. 1 radio receiver bracket from the radio and display receiver assembly.

  6. REMOVE NO. 2 RADIO RECEIVER BRACKET


    1. B0048OQ

      Remove the 2 screws and No. 2 radio receiver bracket from the radio and display receiver assembly.