STEERING ANGLE SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the spiral cable sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Simple intelligent parking assist system*1
Toyota parking assist-sensor system*1
Pre-collision system
Initialize back door lock Power door lock control system

Click here

Removal/installation of the spiral cable with sensor sub-assembly Steering angle neutral point (Initialize intelligent clearance sonar system)

  • Simple Intelligent Parking Assist System

  • Toyota parking assist-sensor system

Click here

*1: When performing learning using the GTS.

Click here

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The following procedure is for LHD vehicles.

PROCEDURE


  1. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Click here

  2. REMOVE STEERING SENSOR


    1. A001Q57C05
      *a Guide

      Disengage the claws and pins, and remove the spiral cable sub-assembly from the steering sensor.

      Note

      Do not damage the pins of the spiral cable sub-assembly or guides of the steering sensor.