FRONT SUSPENSION MEMBER COMPONENTS
Info Added 2017-10-06 
ILLUSTRATION
| *1 | NO. 1 ENGINE UNDER COVER | *2 | REAR ENGINE UNDER COVER LH |
| *3 | REAR ENGINE UNDER COVER RH | - | - |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | FRONT FLOOR COVER LH | *2 | FRONT FLOOR COVER RH |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | COLUMN HOLE COVER SILENCER SHEET | *2 | FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH |
| *3 | FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH | *4 | FRONT STABILIZER LINK ASSEMBLY LH |
| *5 | FRONT STABILIZER LINK ASSEMBLY RH | *6 | FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY |
| *7 | NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY | *8 | NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY |
| *9 | REAR SIDE RAIL REINFORCEMENT SUB-ASSEMBLY LH | *10 | REAR SIDE RAIL REINFORCEMENT SUB-ASSEMBLY RH |
| *11 | TIE ROD END SUB-ASSEMBLY LH | *12 | TIE ROD END SUB-ASSEMBLY RH |
| *13 | COTTER PIN | *14 | WIRE HARNESS CLAMP BRACKET |
 |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | |
N*m (kgf*cm, ft.*lbf): Specified torque |
| ● | Non-reusable part | - | - |
ILLUSTRATION
| *1 | ENGINE MOVING CONTROL ROD | *2 | FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH |
| *3 | FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH | *4 | FRONT NO. 1 STABILIZER BRACKET LH |
| *5 | FRONT NO. 1 STABILIZER BRACKET RH | *6 | FRONT STABILIZER BAR |
| *7 | FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY | *8 | HOLE PLUG |
| *9 | STEERING LINK ASSEMBLY | *10 | FRONT SUSPENSION MEMBER SET PLATE |
| |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | * | For use with SST |
| ● | Non-reusable part | - | - |