REAR COIL SPRING INSTALLATION

Info Added 2017-10-06

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL REAR UPPER COIL SPRING INSULATOR


    1. Install the rear upper coil spring insulator to the vehicle.

  2. INSTALL REAR LOWER COIL SPRING INSULATOR


    1. Install the rear lower coil spring insulator to the rear No. 2 suspension arm assembly.

  3. INSTALL REAR COIL SPRING


    1. A005MPAC02
      *a Identification Mark
      *b 30° or less
      B0048I2 Inner Side of the Vehicle

      Set the rear coil spring to the rear No. 2 suspension arm assembly.

      Note


      • Set the rear coil spring so that its lower end is within the range shown in the illustration.

      • Set the rear coil spring so that the identification mark is positioned as shown in the illustration.

    2. A005NK2C02
      *a Wooden Block
      *b Jack

      Using a jack and wooden block, slowly jack up the rear No. 2 suspension arm assembly and then install the rear No. 2 suspension arm assembly to the rear axle carrier sub-assembly with the bolt and nut.

      CAUTION:

      A005NFX

      • Do not raise the jack up too high.

      • The vehicle could fall, resulting in a serious accident.

      Note


      • Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.

      • When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.

      • Make sure to perform this operation with the vehicle kept as low as possible.

      • Insert the bolt with the threaded end facing the front of the vehicle.

  4. STABILIZE SUSPENSION

    Click here

  5. INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY


    1. A005OAN

      Install the rear No. 2 suspension arm assembly (rear axle carrier sub-assembly side) with the bolt.

      Torque:
      73 N*m  { 744 kgf*cm, 54 ft.*lbf }

      Note

      Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.

  6. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Height Control Sensor)

    Click here

  7. INSTALL REAR FLOOR SIDE MEMBER COVER LH

    Click here

  8. INSTALL REAR FLOOR SIDE MEMBER COVER RH

    Click here

  9. INSTALL REAR WHEEL

    Click here

  10. INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY


    1. Install the rear No. 2 suspension arm assembly (rear suspension member sub-assembly side) with the nut.

      Click here

  11. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

    Click here

  12. PERFORM INITIALIZATION (w/ Height Control Sensor)

    Click here