REAR AXLE HUB INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY


    1. Install the rear axle hub and bearing assembly and rear disc brake dust cover sub-assembly to the rear axle carrier sub-assembly with the 4 bolts.

      Torque:
      90 N*m  { 918 kgf*cm, 66 ft.*lbf }

  2. INSTALL REAR DISC

    Click here

  3. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  4. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  5. REMOVE REAR DISC

    Click here

  6. INSPECT REAR AXLE HUB BEARING LOOSENESS

    Click here

  7. INSPECT REAR AXLE HUB RUNOUT

    Click here

  8. INSTALL REAR DISC

    Click here

  9. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  10. CONNECT SKID CONTROL SENSOR WIRE


    1. Connect the skid control sensor connector to the rear axle hub and bearing assembly.

  11. INSTALL REAR WHEEL

    Click here

  12. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL


    1. Connect the reservoir level switch connector.

    2. Connect the cable to the negative (-) auxiliary battery terminal.

      Click here

    3. Turn the power switch on (READY).

    4. Depress the brake pedal and release it.

    5. Clear the DTCs.

      Click here

  13. CHECK FOR SPEED SENSOR SIGNAL

    Click here