MILLIMETER WAVE RADAR SENSOR REMOVAL

Info Added 2017-10-06

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during millimeter wave radar sensor assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Millimeter wave radar sensor assembly Adjust millimeter wave radar sensor assembly

  • Dynamic radar cruise control system

  • Pre-collision system

  • Forward recognition camera system

  • Lane departure alert system (w/ Steering Control System)

  • Road sign assist system

Click here

PROCEDURE


  1. REMOVE FRONT BUMPER ASSEMBLY

    Click here

  2. REMOVE NO. 1 MILLIMETER WAVE RADAR SENSOR BRACKET


    1. A005O6X

      Remove the 2 bolts.

    2. Disengage the guide and remove the millimeter wave radar sensor bracket.

  3. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY


    1. A005MRGC01
      B0048I2 Bolt
      B0048S8 Screw

      Remove the 2 bolts and screw.

    2. Disengage the 2 guides and remove the millimeter wave radar sensor assembly.

      Note

      Do not reuse the millimeter wave radar sensor assembly if it has been dropped or subjected to a severe impact.