TRANSMISSION CONTROL CABLE REMOVAL

Info Added 2017-10-06

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transmission control cable assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Simple intelligent parking assist system*1
Toyota parking assist-sensor system*1
Pre-crash safety system
Initialize back door lock Power door lock control system

Click here

Gas leak from exhaust system is repaired Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here


CAUTION:


  • A005MLE

    When the engine is hot, do not touch high-temperature areas such as the engine or exhaust pipe.

  • Touching high-temperature areas such as the engine and exhaust pipe could result in burns.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. SECURE VEHICLE


    1. Fully apply the parking brake and chock a wheel.

      CAUTION:


      • A005NBS

        Make sure to apply the parking brake and chock a wheel before performing this procedure.

      • If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.

  4. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  5. REMOVE REAR ENGINE UNDER COVER LH

    Click here

  6. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

    Click here

  7. REMOVE REAR CONSOLE BOX ASSEMBLY

    Click here

  8. REMOVE FRONT FLOOR CENTER BRACE

    Click here

  9. REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

    Click here

  10. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR


    1. A001NTD

      Remove 3 nuts and front No. 1 floor heat insulator from the vehicle body.

  11. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Move the shift lever to N.

    2. A005O7PC01
      B0048R7 Remove in this Direction

      Disconnect the end of the transmission control cable assembly from the floor shift shift lever assembly.

    3. A005NXFC01
      *1 Slider
      B0048I2 Push
      B0048R7 Remove in this Direction

      Push in the slider and remove the transmission control cable from the floor shift shift lever assembly as shown in the illustration.

    4. A001QE8

      Remove the nut to disconnect the transmission control cable assembly from the control shaft lever.

    5. Remove the clip to disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.

    6. A001S14

      Disengage the clamp to separate the transmission control cable assembly.

    7. Remove the bolt to disconnect the transmission control cable assembly from the cylinder head cover sub-assembly.

    8. A001QJR

      Remove the nut.

    9. Disengage the guide to disconnect the transmission control cable assembly from the vehicle body.

    10. A001OFH

      Remove the 2 nuts and transmission control cable assembly from the vehicle body.