CAMSHAFT COMPONENTS
Info Added 2017-10-06 
ILLUSTRATION
| *1 | NO. 1 ENGINE UNDER COVER | - | - |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *A | for LHD | - | - |
| *1 | COWL BODY MOUNTING REINFORCEMENT LH | *2 | COWL BODY MOUNTING REINFORCEMENT RH |
| *3 | NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL | *4 | OUTER COWL TOP PANEL SUB-ASSEMBLY |
| *5 | WATER GUARD PLATE LH | - | - |
 |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | |
N*m (kgf*cm, ft.*lbf): Specified torque |
ILLUSTRATION
| *A | for RHD | - | - |
| *1 | COWL BODY MOUNTING REINFORCEMENT LH | *2 | COWL BODY MOUNTING REINFORCEMENT RH |
| *3 | NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL | *4 | OUTER COWL TOP PANEL SUB-ASSEMBLY |
| *5 | WATER GUARD PLATE LH | - | - |
| |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | |
N*m (kgf*cm, ft.*lbf): Specified torque |
ILLUSTRATION
| *1 | ENGINE WIRE | *2 | NO. 1 FUEL VAPOR FEED HOSE |
| *3 | FUEL VAPOR FEED PIPE | *4 | IGNITION COIL ASSEMBLY |
| *5 | NO. 2 VENTILATION HOSE | *6 | NO. 2 FUEL VAPOR FEED HOSE |
| *7 | NO. 8 WATER BY-PASS HOSE | *8 | PURGE VALVE (PURGE VSV) |
| *9 | NO. 9 WATER BY-PASS HOSE | *10 | EGR PIPE ASSEMBLY |
| *11 | EGR PIPE GASKET | *12 | INLET EGR GASKET |
| *13 | TRANSMISSION CONTROL CABLE ASSEMBLY | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | CAMSHAFT POSITION SENSOR | *2 | CAMSHAFT |
| *3 | NO. 2 CAMSHAFT | *4 | SPARK PLUG TUBE GASKET |
| *5 | CYLINDER HEAD COVER SUB-ASSEMBLY | *6 | CYLINDER HEAD COVER GASKET |
| *7 | CAMSHAFT TIMING GEAR ASSEMBLY | *8 | CAMSHAFT TIMING SPROCKET |
| *9 | NO. 1 CAMSHAFT BEARING CAP | *10 | NO. 2 CAMSHAFT BEARING CAP |
| *11 | GASKET | *12 | NO. 2 CHAIN VIBRATION DAMPER |
| *13 | NO. 1 CHAIN TENSIONER ASSEMBLY | *14 | BRACKET |
| *15 | NO. 1 CAMSHAFT BEARING | *16 | NO. 2 CAMSHAFT BEARING |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | *T1 | For use with SST |
| *T2 | For use with SST and a union nut wrench | ● | Non-reusable part |